Theantenna is shipped almost completely assembled. All you need to do is install the 1/2 inch Aluminum tubing at both ends of the 10 Meter and 6 Meter antennas, adjust them to the proper length and tighten the hose clamps that hold them in place. The antenna is then ready to install on your vertical pipe and Rotator. 10N6RDB Radiation Pattern ABrief Synopsis of the Antenna Features & characteristics In this article, I will try to cover various aspects of the End-Fed Half-Wave (EFHW) wire antenna including, its geometry, characteristics, performance parameters, the influence of the practical surrounding environment where the antenna might be deployed, as well as transmission line interfacing. Easyto build antenna for 2 meters. Follow along as i show you how to build a Quarter wave ground plane for 2 meters. From start to finish i walk you thrual Whenbuilding any antenna system, the builder will need some kind of matching system if the antenna is not resonant around the 50 ohms point. Many high-performance monoband Yagi's exhibit feed point impedances of around 25-35 ohms. A hairpin being used on a 2 element Yagi. We'd fit a 1:1 choke balun at the feed point to prevent common .

how to build a 2 meter yagi antenna